| Camera Maker | Nikon Corporation | Camera Model | NIKON D90 |
| Aperture | f/9 | Color Space | sRGB |
| Exposure Value | 0 EV | Exposure Program | Unknown: 0 |
| Exposure Time | 1/200 sec | Flash | Flash, Auto-Mode, Return light detected |
| Focal Length | 105 mm | ISO | 200 |
| Metering Mode | Pattern | Date/Time | 2017:06:15 22:47:44 |
| Resolution Unit | Inch | X Resolution | 240 dots per ResolutionUnit |
| Y Resolution | 240 dots per ResolutionUnit | Compression | Jpeg Compression |
| Contrast | 0 | Exposure Mode | 0 |
| Saturation | 0 | Scene Type | Directly Photographed |
| Sharpness | 0 | Caption | The USB startup fix consists of adding a jumper between a resistor near the ribbon cable connector and a capacitor at the edge of the board. I'm assuming the capacitor is on the chip power supply coming from the 12V input and the resisotr is going to the reset pin of the USB chip. That would hold the USB chip in reset until the power supply comes up. Normally a mod like this would also include cutting a trace to break the original connection, but hopefully this will work! These are 0402 parts so they had to be done under a microscope with my finest SMT tipped soldering iron and even then it was a challenge. I also had to carefully remove the conformal coating around the area. |